Cleat screws are the small, yet critically important, fasteners connecting the cycling shoe to the pedal system. They are subjected to incredible strain: relentless cyclic forces from every pedal stroke, high-frequency road vibration, and severe exposure to dirt and moisture. A loose cleat screw can lead to rotational slippage, knee pain from incorrect positioning, and catastrophic release failure. However, precise cleat positioning requires frequent adjustment for biomechanical fine-tuning.
Don’t let slippage ruin your ride or cause injury; secure the position while maintaining future adjustability.
INCURE Re-Lok™ B22 Purple Light Duty Threadlocking Adhesive
For small, critical fasteners like cleat screws (typically M5 or M6), which require security against vibration but must be easily removable for precise adjustment, low strength is the perfect balance. The INCURE Re-Lok™ B22 Purpleprovides a secure, anti-vibration lock designed for small threads, ensuring they hold their position until you are ready to adjust them.
| Feature & Benefit | Technical Insight for Cleat Screws | Conversion Value |
| Low Strength (Light Duty) | Provides enough thread lock to prevent vibration-induced loosening for fasteners up to M6, allowing for easy removal with basic hand tools. | Precision & Service: Lock down the precise fit position without the risk of stripping threads during fine adjustments. |
| Small Fastener Focus | Ideal for the low torque requirements of small shoe sole inserts, preventing over-stressing or damaging the cleat or shoe material. | Shoe-Safe Security: Designed for small fasteners where high torque and permanent bonding are detrimental. |
| Controlled Lubricity | Ensures consistent clamp loads during torquing, which is vital for achieving accurate tension without overtightening and cracking plastic soles. | Torque Accuracy: Achieve the manufacturer’s specified tension reliably for safe clipping and unclipping. |
| Corrosion Protection | The cured adhesive acts as a sealant, blocking dirt and moisture from reaching the threads, which prevents rust and subsequent difficulty in removal. | Maintain Removability: Ensure your screws remain easy to adjust or replace, regardless of how many wet rides you take. |
Application Steps: Securing Cleat Screws for Biomechanical Integrity
Preparation (Essential): Remove all existing screws. Clean the threads of the screws and the metal cleat inserts in the shoe sole thoroughly with a degreasing solvent. Wipe surfaces until perfectly dry.
Application: Apply a single, small drop of Re-Lok™ B22 Purple to the middle threads of each cleat screw. Only a minimal amount is necessary for the small thread area.
Assembly: Mount the cleat and adjust it to the desired position. Tighten the screws evenly to the manufacturer’s specified torque value. Do not over-torque.
Curing Time (Practical): While the initial cure is fast (around 20 minutes), allow a few hours for the adhesive to fully set before subjecting the cleat system to full power and vibration on a ride.
Stop risking dangerous mechanical failures and secure your safety-critical components with the toughest chemical integrity.