A poured-in-place gasket only works if it seals on the first try and stays sealed through vibration, temperature swings, and chemical exposure. Cut gaskets shift, compress unevenly, and leave gaps at corners. Incure Uni-Seal 3393 is a light-curable form-in-place and cure-in-place gasket material built to seal complex geometries in electronics and automotive assemblies. Form-in-Place and Cure-in-Place Basics A form-in-place gasket (FIPG) is dispensed as a bead directly onto one mating surface, then cured before assembly so it behaves like a precision-molded seal. A cure-in-place gasket (CIPG) follows the same idea but is compressed between surfaces during cure. Both approaches eliminate gasket inventory, adapt instantly to design changes, and follow irregular flange paths that a die-cut part cannot. Why Uni-Seal 3393 Uni-Seal 3393 cures under UV, visible, or LED light and is engineered around the needs of sensitive electronics: Acid-free chemistry that will not corrode copper, solder, or fine-pitch leads Low viscosity for precise dispensing and penetration into narrow channels Tack-free cure leaving a clean, handleable surface with no residue transfer Air-tight sealing against moisture, dust, and pressure differentials Ease-of-peel rework, so a module can be opened for repair and resealed Moisture, temperature, and chemical resistance for under-hood and outdoor service Dual use as a temporary mask during downstream conformal coating Designing a Reliable Poured Gasket Bead geometry drives the seal. Specify a groove or a defined land width so the dispensed bead has a consistent cross-section and a target compression, generally 20 to 40 percent, when the housing closes. Too little compression leaks; too much extrudes material and can bottom out the joint. Dispense control is the other half. A positive-displacement dispense head holds bead volume constant as the material warms or the reservoir empties, and programmed paths keep the bead centered on the flange around tight corners. After dispensing, the assembly passes under a lamp sized to the part so the entire bead reaches full cure. Because a cured gasket and a metal or plastic housing expand at different rates, a seal that is fine at room temperature can open up in the cold or over-compress when hot. Considering how thermal expansion mismatch stresses a bonded or sealed joint guides the choice between a firmer or a more compliant gasket. Matching the material to a suitable UV LED flood lamp or an inline conveyor system keeps cure time in step with line speed. For help fitting Uni-Seal 3393 to a flange design and dispense process, Email Us with your housing drawings. Poured Gaskets Versus the Alternatives Die-cut elastomer gaskets carry a hidden cost: tooling for each new shape, inventory for each part number, scrap from the cut, and assembly labor to place them without pinching or misaligning. They also seal poorly at tight radii and sharp corners, exactly where enclosures tend to leak. A poured gasket forms to the flange path automatically and needs no part-specific tooling. Room-temperature-vulcanizing (RTV) silicone beads solve the fit problem but cure slowly from the surface inward, so a thick bead can stay soft…