Bubbles in a cured UV glue line are more than a cosmetic flaw. Each void concentrates stress, gives a crack an easy path, scatters light in an optical joint, and can trap uncured adhesive that keeps outgassing. Preventing them is mostly about how the adhesive is dispensed and cured; removing them once cured means rework. Where the Bubbles Come From Air folded in during dispensing. Pumping adhesive too fast, a partially empty cartridge, or dragging the nozzle across the bead all whip air into the glue. Air trapped between the parts. Bringing two flat surfaces together traps whatever air was between them, especially with a thick bead or a closed-perimeter joint that has no vent path. Outgassing from the substrate. Porous materials, untreated plastics, and surfaces with absorbed moisture release gas when the adhesive covers them or when cure heat drives it out. Boiling from cure exotherm. A thick section of high-intensity cure can heat the adhesive enough to generate vapor bubbles. Solvent or moisture in the adhesive. Contaminated or old adhesive, or a primer that was not allowed to flash off, adds volatiles that bubble during cure. Step-by-Step: Preventing Bubbles 1. Degas the adhesive. Let a fresh cartridge or bottle sit so entrained air rises out. For critical work, place the adhesive in a vacuum chamber for a few minutes until it stops foaming, then let it settle. 2. Dispense slowly and stay submerged. Keep the nozzle tip inside the adhesive already laid down so the bead grows without folding in air. Use the largest practical nozzle for the viscosity. 3. Apply a thin, even bead. Thin layers give trapped air a short path to the surface and lower the cure exotherm. Avoid thick fillets where you can. 4. Close the joint with a wetting motion. Bring one edge into contact first and roll the second surface down so air is pushed out ahead of the closing line rather than trapped in the middle. 5. Let it dwell before cure. Give the assembled joint 30 to 60 seconds so small bubbles migrate out and the adhesive wets fully. On clear joints you can watch the bubbles clear. Larger bubbles rise faster than small ones, so a thin bond line where the trapped bubble is only a fraction of a millimeter from a free edge clears far quicker than a thick one. This is another reason thin, even application beats a heavy fillet. 6. Warm slightly if the adhesive is cold. Cold adhesive is more viscous and holds bubbles. Bringing it to room temperature or slightly above lowers viscosity so air escapes. 7. Cure with even, controlled intensity. Do not blast a thick joint with maximum intensity. Use a source sized to the part so the whole bond line sees the same dose without a hot spot; matching an L-Series UV LED flood lamp to the curing area covers this. A cure chamber matched to the lamp and part gives a repeatable, uniform dose. 8. Confirm full cure. Undercured adhesive…