Incure Cyro-Weld™ CM-4000: High-Viscosity Cyanoacrylate Adhesive
When a joint has a large or uneven gap, or when the adhesive absolutely cannot migrate into a nearby feature, even a standard high-viscosity cyanoacrylate is not thick enough. Incure Cyro-Weld™ CM-4000 is a gel-consistency, very-high-viscosity grade for the widest-gap and highest-control joints on external and disposable devices. Gel Consistency and Why It Helps A gel cyanoacrylate does not flow at all until it is worked. It can be placed as a discrete deposit, it holds a tall fillet, and it will not creep along a seam or wick into a threaded feature, a vent, or a moving mechanism next to the joint. That makes it the grade to reach for when the consequence of stray adhesive is a scrapped assembly. CM-4000 is a single-component grade in the Cyro-Weld™ CM series, formulated to meet ISO 10993-5 for cytotoxicity, and intended for external, disposable, and wearable components rather than implanted parts. Incure Cyro-Weld™ CM-4000 at a Glance Chemistry: single-component, room-temperature-cure cyanoacrylate Viscosity: very high, gel consistency, non-migrating Fixture speed: tens of seconds to minutes; the slowest-fixturing CM grade because of bond-line thickness Bond strength: high shear strength on suitable rigid plastics Gap capability: the widest of the CM series, with an activator to drive cure Biological safety: formulated to meet ISO 10993-5 for cytotoxicity Sterilization: compatible with validated ethylene oxide and gamma processes; confirm with Incure Where CM-4000 Fits Wide or uneven gaps: joints where molded-part variation leaves the bond line inconsistent and large Fillet reinforcement: building a structural fillet at the base of a bonded post or bracket Sensitive-neighbor joints: bonding next to vents, threads, membranes, or mechanisms that must stay clean Point deposits: placing a controlled dab to lock a fastener or retain a small component Process Control for Gel Cyanoacrylate A gel this thick will not fully cure on its own through a large bond line in a reasonable time. Plan on an activator applied to one face, or a two-step approach where a thin activated skin fixtures the part and full-depth cure completes over hours. Because the deposit is a significant mass, expect a measurable exotherm and keep it away from thin, heat-sensitive plastic walls. Dispense from a tapered tip with steady pressure so deposit size is repeatable. Keep humidity between 40 and 60 percent. For a wider view of picking an adhesive against gap and load, see matching adhesive grade to viscosity and tensile requirement. Where the joint spans dissimilar materials, review how CTE mismatch causes adhesive bond failure. Storage, Shelf Life, and Handling Store unopened CM-4000 refrigerated at 2–8°C and let each bottle or applicator reach room temperature before opening so condensation does not enter the container. Reseal after every use, keep the air headspace low, and use within the opened shelf life on the label. Because the gel already sits at the high end of the viscosity range, a bottle that has thickened further should be quarantined rather than forced through a dispense tip. Rotate stock first-in-first-out, record lot numbers in the device history…