A UV adhesive can cure perfectly and still fail if it was never suited to the substrates it holds. Material compatibility, the ability to wet, adhere to, and stay bonded to a specific material in service, is what separates a durable joint from an early delamination. What Drives Compatibility Compatibility is not a single property. It is the combined result of how the adhesive interacts with each surface: Surface energy. The adhesive must have a lower surface tension than the substrate to spread and wet it. High-energy surfaces like glass, ceramic, and clean metal wet easily. Low-energy plastics such as polyethylene, polypropylene, and PTFE resist wetting and need treatment or a primer. Porosity. Porous materials absorb resin away from the interface, starving the bond line. Non-porous rigid parts hold the adhesive where it is needed. Chemical makeup. Plasticizers, mold-release agents, and residual monomers can migrate into the bond line and weaken it over time. Thermal expansion. When two bonded materials expand at different rates, the interface carries cyclic stress. This is a leading cause of long-term failure, explained in our article on how CTE mismatch causes adhesive bond failure. Common Compatibility Problems Manufacturers see the same failure modes repeatedly. Poor initial adhesion shows up as a bond that peels cleanly off one surface, leaving no residue. Contamination from fingerprints, cutting fluid, or silicone spray produces scattered weak spots. Stress cracking appears at the adhesive edge weeks after assembly. Yellowing or hazing at the interface signals a chemical reaction between resin and substrate. For transparent assemblies, choosing between light-cure and two-part chemistry affects both clarity and durability. Our guide to UV glue versus epoxy for transparent bonding walks through the tradeoffs. Building a Compatible Bond Prepare the surface. Solvent-wipe to remove oils, then abrade or plasma-treat low-energy plastics. Verify wetting with a dyne pen or a water-break test before applying adhesive. Match the adhesive to the substrate. A grade formulated for polycarbonate is not the same as one formulated for glass or stainless steel. Confirm the manufacturer lists your material. Use a primer where needed. Adhesion promoters give a chemical anchor on difficult surfaces such as polyolefins, fluoropolymers, and some silicone rubbers. Test before production. Bond representative parts, then subject them to the environment the product will see: thermal cycling, humidity soak, and the expected mechanical load. Peel or lap-shear results after aging tell you far more than a fresh-bond number. If you need a starting point for a specific material pair, Email Us with the substrate names and the service conditions. Bonding Dissimilar Materials Joints between glass and metal, or plastic and metal, are common and demanding because the two sides move differently with temperature. Options include a slightly flexible adhesive that absorbs the strain, a joint design that keeps the bond area small, and grades developed specifically for mixed substrates. For glass-to-metal work, see our overview of matching a UV glass and metal bonder grade to viscosity and tensile requirements. Consider a display window bonded into an aluminum frame…