Electronics that run hot, sit outdoors, or live inside a machine face a punishing mix of heat, moisture, vibration, and chemicals. A potting compound that passes a bench test can still crack or absorb water after a season in the field. Incure Uni-Seal 6213HT is built for assemblies that must keep working under those conditions. What Potting Does Potting fills the cavity around a circuit or component with a solid resin, creating a continuous barrier against the environment and a mechanical anchor against shock and vibration. Unlike a thin conformal coating, a potted section is fully encased, which raises protection but also puts the resin in intimate contact with every component. That makes two properties critical: low stress on the parts and stable behavior across temperature. Where Uni-Seal 6213HT Fits Uni-Seal 6213HT is a thick-viscosity adhesive that cures under UV, visible, or LED light, with heat as a secondary path for shadowed regions. The high viscosity keeps it in place on vertical walls and around tall components during application, and the multi-mode cure lets it set fully even where light cannot reach every surface. Key characteristics for demanding service: Deep single-pass potting to roughly 5 mm, forming a hard solid pot without repeated lifts Chemical resistance to mineral oils, fuels, gases, and common industrial solvents Low water absorption and low shrinkage, which limits dimensional change and internal stress over the service life Adhesion to metals, glass, and ceramics, so the pot stays bonded to the housing and substrate Smooth cured finish suitable for inspection and downstream handling Selecting and Applying a Potting Compound Match the resin to the environment. For high-temperature or chemically aggressive service, prioritize a low coefficient of thermal expansion, a glass transition temperature above the maximum operating temperature, and demonstrated resistance to the specific fluids present. For assemblies that dissipate significant heat, a thermally conductive grade moves that heat into the housing instead of trapping it. Process control determines whether those properties actually reach the finished part: Prepare surfaces. Clean off flux residue, oils, and mold release so the resin can wet and bond the substrate. Manage the exotherm. In deep or large-volume pots, cure in controlled steps so reaction heat does not spike and generate voids or shrinkage stress. Remove entrapped air. Vacuum degassing before or during pour prevents bubbles that concentrate stress and reduce dielectric performance. Cure completely. Confirm shadowed regions receive the secondary heat cycle, and verify hardness against the datasheet before releasing parts. Because the resin and the components expand at different rates, thermal cycling is where marginal potting jobs fail. Reviewing how expansion mismatch drives cracking and delamination helps explain why a compliant, low-shrinkage resin outlasts a harder, higher-stress one in cycling service. UV and visible-light potting resins also depend on adequate cure energy, so pairing the material with the right LED flood lamp for the curing area is part of the specification. For help evaluating Uni-Seal 6213HT against your temperature, chemical, and mechanical requirements, Email Us with your operating conditions. Thermal…