A high-temperature adhesive is only useful on the production floor if you can actually apply it. Incure Epo-Weld™ UHTE-5322 pairs a wide service range with a room-temperature cure, so shops without an oven can still bond and pot parts that will run hot. What sets UHTE-5322 apart Epo-Weld™ UHTE-5322 is a two-part epoxy that holds performance across a range of roughly -60°C to 300°C (-76°F to 572°F) and works for both bonding and potting. Its defining feature within the Ultra High Temperature family is that it cures at ambient temperature. Most epoxies rated for this kind of heat need an oven cure to reach full properties; UHTE-5322 reaches a usable cure on the bench, which simplifies the process for repair work, large assemblies that will not fit in an oven, and heat-sensitive components nearby. The cured system resists a wide set of solvents, fuels, and dilute acids and bases, and it develops strong tensile and flexural strength. Key properties and what they mean Wide thermal range. The same grade covers cold-soak conditions and sustained heat, which matters for equipment that cycles between the two, such as transport hardware and outdoor industrial installations. Room-temperature cure. No oven means lower energy cost, no fixture bake-out, and no risk of thermally damaging adjacent parts. An optional mild heat cure still speeds the schedule and lifts the final glass transition temperature if you want it. Bonding and potting in one product. You can use a single qualified material for both structural joints and encapsulation, which cuts down on inventory and qualification work. Chemical resistance. The matrix holds up to cleaning chemistry and process fluids over long exposure. Where UHTE-5322 fits Aerospace and defense: potting connectors and bonding brackets on assemblies too large or heat-sensitive for an oven cure. Automotive and transportation: encapsulating sensors and bonding hardware in engine-bay and exhaust-adjacent locations. Electronics in hot environments: potting power components and control modules that run near their thermal limits. Industrial ovens and dryers: bonding instrumentation and support hardware during on-site maintenance. Rail and transit systems: field repairs on traction and braking equipment where an oven is not available. Bonding and potting practice For potting, pour in thin passes and let each pass release trapped air before adding more; a deep single pour tends to hold voids and can exotherm if the mass is large. For bonding, control the bond line to roughly 0.1 to 0.25 mm and design the joint for shear loading. When you bond or pot around ceramics, glass, or dissimilar metals, plan for thermal expansion differences; the stress that builds at every temperature change is a leading cause of bond-line cracking, as explained in this guide to how CTE mismatch causes adhesive bond failure. If you are potting a module and are not sure how the exotherm will behave in your pour volume, Email Us with the cavity dimensions and fill depth. Surface preparation Degrease every substrate with a clean solvent, abrade metals to expose fresh material, then wipe again and let the…